SlackBuilds Repository

15.0 > System > firmware-gobi-2000 (0.7)

Firmware and loader for Qualcomm Gobi USB chipsets. These
devices appear in an uninitialised state when power is applied and
require firmware to be loaded before they can be used as modems.
gobi_loader adds a udev rule that will trigger loading of the
firmware and make the modem usable.

Note:

No carrier specific card configuration may work with `CARRIER=UMTS'
(default) or `CARRIER=6' else pass `CARRIER=<sub-directory>' to the
SlackBuild matching your carrier or reseller/franchiser which is using
the carrier. It's strongly encouraged to explicit select a carrier.

After installation restart your system or use
`udevadm control --reload && udevadm trigger`.

For carrier information, see README.SBo

This requires: innoextract, msitools

Maintained by: Marcel Saegebarth
Keywords: thinkpad,qualcomm,mobile,broadband,wwan,ev-do,cdma,gsm,gprs,edge,hspa,umts,agps
ChangeLog: firmware-gobi-2000

Homepage:
http://www.codon.org.uk/~mjg59/gobi_loader/

Source Downloads:
gobi_loader-0.7.tar.gz (c3aca13541be3b29e3700149256aadb6)
7xwc48ww.exe (629985df8599b3815211ddcffbb6bad5)

Download SlackBuild:
firmware-gobi-2000.tar.gz
firmware-gobi-2000.tar.gz.asc (FAQ)

(the SlackBuild does not include the source)

Validated for Slackware 15.0

See our HOWTO for instructions on how to use the contents of this repository.

Access to the repository is available via:
ftp git cgit http rsync

© 2006-2024 SlackBuilds.org Project. All rights reserved.
Slackware® is a registered trademark of Patrick Volkerding
Linux® is a registered trademark of Linus Torvalds